Ross Synergy 2 SD, Installation Manual

Page: 151 / 414

Synergy Series Installation Guide (v18) BNC Configuration and Check • 6–19
5. Use the
N/S Control
knob to select between the following:
•
Individual
— Select this option to disable the N/S LED for the selected BNC input
only.
•
All OFF
— Select this option to turn all the N/S Disable setting Off . This will
override all the individual N/S Disable settings, and return the BNCs to a N/S
Disable
OFF
mode.
•
All ON
— Select this option to turn all the N/S Disable setting On . This will
remove the override that would have been set by selecting the
All OFF
option on
any other BNC.
This completes the procedure for disabling the N/S LEDs.
Exiting the Setup Menus
When you exit the Setup Menus (typically by pressing HOME ), the system provides visual warning
and asks you to confirm the changes. This warning occurs only when the following conditions are
met:
• The Installation Enable Jumper ( JP10 ) on the front edge of the Frame CPU Board is
in the Down position.
• A change has been made on an Installation Menu .
When you press HOME to exit the Installation Menu , the following Installation Change
Confirmation Menu is displayed:
Installation Change Confirmation Menu
This menu alerts you that settings are about to be changed:
• Press Confirm to accept the changes.
• Press Cancel to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
Note When you return the settings to Individual after an All OFF or All
ON setting, the original settings will preserved.
Important
If all installation changes are now complete, return the Installation
Enable Jumper ( JP10 ) on the front edge of the Frame CPU Board
to the Up position in order to lock installation.