Ross Synergy 2 SD, Installation Manual

Page: 150 / 414

6–18 • BNC Configuration and Check Synergy Series Installation Guide (v18)
Aux Bus Setup Menu — Shift Mapping Message
Bus Hold Function
The Bus Hold function allows you to retain the currently selected video crosspoint on a bus during a
memory recall. If the BUS HOLD button is assigned to a crosspoint, each bus BKGD (or PGM), PST,
Key 1, and Key 2, on all MLEs, can be held independently. Refer to the Synergy Series Operation
Guide for information on using the Bus Hold function.
If the Bus Hold Clear function has been enabled in the Personality Menu , you can turn off all the
Bus Holds by performing a soft reset (pressing ALL + ALL ).
Setting Up N/S Disable
The N/S Disable Menu gives you the option to disable the non-sync LEDs for all or individual BNCs.
When a BNC has the N/S Disable set to ON , the non-sync indicator on the panel will not light for
this BNC, even if this source is un-synchronized.
Use the following procedure to disable the non-sync LEDs:
1. Navigate to the BNC Menu 2-3 as follows:
• Press
HOME B MORE B Setup B Installation B BNC B MORE
.
2. Press
N/S Disable
to display the N/S Disable Menu .
BNC — N/S Disable Menu
3. Use the BNC knob to select the BNC input that you want to turn the N/S Disable feature
on for.
4. Use the N/S Disable knob to turn the N/S Disable on or off as follows:
• ON — Select this option if you want to enable the N/S Disable feature.
•
OFF
— Select this option if you want to disable the N/S Disable feature. This is the
default setting.