Ross Synergy 2 SD, Installation Manual

Page: 142 / 414

6–10 • BNC Configuration and Check Synergy Series Installation Guide (v18)
Use the following procedure to set your input types:
1. Navigate to the BNC Menu 1-3 as follows:
• Press
HOME B MORE B Setup B Installation B BNC
.
2. Press
BNC Type
to display the BNC Type Menu .
BNC — BNC Type Menu
3. Use the
BNC
knob to select the BNC input that you want to assign an input type to.
4. Use the
Type
knob to select the desired input type. You can select from the following:
• Off — Select this option when there is no input physically connected to the selected
BNC. Selecting Off filters the input out of subsequent menus.
•
DVE
— Select this option when a DVE “fill” signal is connected to the selected
BNC. You must have the DVE Send and Remote Control Software Option in
order to control a DVE from the Synergy switcher.
•
VTR
— Select this option when a VTR, Video Server, or Audio Server is connected
to the selected BNC. You must have the VTR Remote Control Software Option in
order to connect a VTR to the Synergy switcher. You will need the Video Server
Control or Audio Server Control Software Options , depending on the device you
are connecting.
•
Reference
— Select this option when a reference video signal is connected to the
selected BNC. The name assigned to the reference input may be
Color Bars
(the
recommended reference signal). Refer to the section “ Setting Up Panel Buttons ”
on page 6–15 for more information on naming panel buttons
Important All BNC input types must be assigned to Video , Alpha , or
Reference , unless the device connected to that BNC input is
controlled by the Synergy switcher.
Note When you assign a remote device to a BNC crosspoint, pressing that
crosspoint button will display the corresponding device control menus.
If it is on a Key bus, pressing the button will cycle through the device
control menus and the
Key Type Menu .
Note When you assign a VTR device to a BNC crosspoint, pressing that
crosspoint button will put the
Global Memory System in either VTR
Clip ID mode or VTR Clip Number mode based on the device. Refer
to the section “ VTR Operation ” for more information.
Important
You can select only one BNC as the reference input.