Ross Synergy 100, Installation Manual, Page: 96 / 246

6–8 • BNC Configuration and Check Synergy 100 Installation Guide (v16.10-S100)
some CGs). The fill video signal, in turn, is matched perfectly by the alpha
signal.
~
No (Unshaped)
— Use this option to have the switcher perform a
multiplicative key . Here, the fill video signal is typically full screen and the key
(alpha) signal simply drops in — cutting a clean hole in the background.
6. Press
MENU
to display the Installation Change Screen .
7. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure for setting up an alpha input.
Setting Up Panel Buttons
As the last step in the BNC configuration process, you can map BNC connectors to physical buttons
on the control panel.
Use the following procedure to set up your control panel inputs:
1. Navigate to the Inputs Menu as follows:
• Press MENU to display the Main Menu .
• Press 1. Inputs to display the Inputs Menu .
Inputs Menu
2. Press 1. Panel to display the Panel Menu .
Operating
Tip
If you are unsure about which mode to select, check the documentation
for your device that provides the alpha signal.
Inputs
0. Inputs
1. Panel
2. Tally
3. Audio
MENU
Exit 100
Previous 10
Down 1
Up SEL
Accept