Ross Synergy 100, Installation Manual, Page: 95 / 246

Synergy 100 Installation Guide (v16.10-S100) BNC Configuration and Check • 6–7
Inputs Menu
2. Press 0. Inputs to display the Inputs Sub-Menu
Inputs Sub-Menu
3. Select the input BNC you want to assign an alpha to as follows:
• Press 0. Input .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the input
BNC you want to assign an alpha to.
• Press the right SEL button to accept the new setting
4. Assign an alpha to the selected input BNC as follows:
• Press 2. AutoKey .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the input
BNC.
• Press the right SEL button to accept the new settings.
5. Assign a Keying mode to the selected Auto Selected Key as follows:
• Press 4. Shaped .
• Press the right SEL button to toggle the Shaped setting between Yes and No as
follows:
~
Yes (Shaped) — Use this option to have the switcher perform an additive key .
Here, the fill video signal is precisely shaped (e.g., characters, in the case of
Operating
Tip
If the input that you are presently configuring does not have an alpha
associated with it, set the AutoKey association for that BNC to
Black .
Inputs
0. Inputs
1. Panel
2. Tally
3. Audio
MENU
Exit 100
Previous 10
Down 1
Up SEL
Accept
Inputs
0. Input
1. Type BNC 1
Off
2. AutoKey
3. Reserved
4. Shaped Black
No
5. Aud Chan1
6. Aud Chan2
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
Chan 1
Chan 2