Ross Synergy 100, Installation Manual, Page: 68 / 246

3–2 • Preliminary Cabling and Check Synergy 100 Installation Guide (v16.10-S100)
Cabling
In this section the following connections are made:
• Control panel to main frame
• Frame to optional remote Aux panels
• Reference input
• Connections to an output monitor
Once these basic connections have been completed, a preliminary functional check can be performed
to ensure that the switcher is passing video. The figure below illustrates the connections that you will
make in this chapter.
Preliminary Cable Connections
Control Cable Installation
Use the following procedure to install the control cable between the electronics frame and the control
panel.
Frame to Control Panel Interconnection
Synergy
Electronics
Frame
Connectors:
PGM
PANEL
AUX
Synergy 100
Control Panel
Program
Monitor
Connectors:
FRAME
Remote Aux Panel
Remote Aux Panel
Up to 8 Panels
POWER
OK -12 +5 +10 +15
SYNERGY
PANEL
AUX
PANEL
210/216 PANEL
100/110 PANEL
MOUNT IN RACK ONLY
100-120 / 200-240V ~
50/60 Hz
2.7A 180W
This class A device complies with Canadian ICES-003 and part 15 of the FCC rules.
Operation is subject to the following conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
R
S
YNERGY