Ross Synergy 100, Installation Manual, Page: 214 / 246

11–6 • Appendix B. Hardware Options Synergy 100 Installation Guide (v16.10-S100)
Floating Border Generator Installation
This section provides instructions for installing the Floating Border Generator option on the Frame
CPU Board.
Use the following procedure to install the Floating Border Generator option:
1. Power down the Synergy 1 frame.
2. Carefully remove the Synergy 1 Frame Board from the chassis, and set it on a clean,
flat, static free surface, with the rear of the board away from you.
3. Unpack the Floating Border Generator kit, consisting of one Floating Border
Generator Module (4000A-049).
4. Locate the 2 sockets labeled “ Dual Border Generator ” on the Synergy 1 Frame
Board , near the left, front of the board.
• Carefully align the module over the sockets.
• Ensure that the components of the Floating Border Generator Module board are
facing up.
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the module until the module is
fully seated. Avoid flexing the board — so as not to bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins. It is recommended that you rotate the board 360 degrees
to check all planes.
5. When complete, carefully replace the Synergy 1 Frame Board into the chassis, and
secure with the outer latches on the board edges.
This completes the installation for the Floating Border Generator option.
Caution
Observe all static discharge precautions throughout the procedure.
Caution
Failure to reinstall a module with a precise 1:1 pin-to-socket
orientation will damage the Synergy 1 Frame Board, the selected
module — or both! Double check your work!