Ross Synergy 100 MD, Operator'S Manual

Page: 294 / 402

17–18 • Squeeze & Tease MD Sequences and Wipes Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Adding a Hold to a Sequence
You can insert a Hold at the end of any Keyframe. A Hold differs from a Keyframe Duration in that
it requires manual input to continue by pressing the AUTO TRANS button.
Adding a Hold to a Sequence
Use the following procedure to add a Hold to a sequence:
1. Navigate to the Sequence Menu as follows:
• Press
FLY KEY
in the Effects Keyers Group to display the S&T MD Menu .
• Press
2. Sequences
to display the Sequence Menu .
Sequence Menu
2. Program the Keyframe. Refer to the section “ Creating a Sequence ” on page 17–6 for
more information.
3. Press 2. Next Keyframe or 1. Previous Keyframe until you reach the Keyframe
you want the sequence to hold at.
4. Press 9. Keyframe Parameters on the Sequence Menu .
5. Press 1. Hold to display the Hold Menu .
Keyframe Parameters — Hold Menu
Important
A Hold is only implemented when running a sequence using
AUTO
TRANS
.
MENU
Exit 100
Previous 10
Down SEL
Accept 1
Up
Sequence Key 1
0. Load/Save Sequence
1. Previous Keyframe
2. Next Keyframe
3. Insert Keyframe
4. Overwrite Keyframe 5. Delete Keyframe
6. Delete Workspace
7. Wipe Modifier
8. Modify Keyframes
9. Keyframe Parameters
Use positioner or Hue, Sat, Lum to modify
Keyframe Parameters
0. Duration 30
1. Hold On
2. Spline Params
Key 1
Hold: On