Ross Synergy 100 MD, Operator'S Manual

Page: 262 / 402

15–6 • Borders Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Border — Size Menu
3. Use the
LUM
knob, or twist the Positioner knob clockwise and counter-clockwise , to
adjust the softness symmetry of the border as follows:
•
0.0%
— This will give you a hard inner edge. Adjustments to softness or
transparency will be applied almost entirely to the interior edge of the border.
•
100.0%
— This will give you a hard outer edge. Adjustments to softness or
transparency will be applied almost entirely to the exterior edges of the border.
This completes the procedure for adjusting the symmetry of the border.
Border Transparency
There are two kinds of transparency that can be applied to the Flying Key border. Edge Transparency
allows you to adjust the level of transparency of the outer and inner edges of the border. Interior
Transparency allows you to adjust the level of transparency of the center of the border.
Use the following procedure to adjust the transparency of the border:
1. Navigate to the Border Menu as follows:
• Press FLY KEY in the Effects Keyers Group .
• Press MENU to display the Main Menu .
• Press 8. S&T MD to display the S&T MD Menu .
• Press 1. Border to display the Border Menu .
2. Press 4. Advanced to display the Advanced Menu .
Note Softness symmetry is not available with horizontal or vertical corners,
or when a border size of 0.0% is selected.
Operating
Tip
You can use the BORDER hotkey to display the Border Menu
directly.
Use positioner or Hue, Sat, Lum to modify
Border 1 2 Key 1
Size Size: 0.0%
Softness: 15.0%
Symmetry: 50.0%
0. Size
1. Style
2. Corners
3. Color
4. Advanced Off 5. Auto Default