Ross Synergy 100 MD, Operator'S Manual

Page: 160 / 402

9–6 • Memory and Disk Functions Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Menu Control Group — Memory Bank Selection
3. Press the pattern button corresponding to the Memory Register you want to recall the
switcher setup from. The switcher setup is recalled.
This completes the procedure for recalling a memory using the Quick Recall method.
Advanced Recall
Use the following procedure to perform an advanced recall:
1. Press the MEM button in the Effects Control Group . The button will illuminate green.
2. Press the 10 (
ª
) button in the System Control Group to select the Bank that contains
the memory register you want to recall.
3. Press the 1 (
©
) button in the System Control Group to select the Memory Register that
you want to recall.
4. Press the right SEL button to recall the memory.
This completes the procedure for recalling a memory using the Advanced Recall method.
Recall Register Notes
Please note the following important points regarding memory register recalls:
• After a recall, the panel responds to the recalled values and not to the current position of
the knobs. This may result in the control knob reaching its mechanical stop before the
full value is reached. If this happens, it will be necessary to rotate the knob away from
the mechanical stop to a point where some change is again observed. At this point, the
knob is will returned to normal operation. This makes it possible to make adjustments on
the program output without observing any jump as the control knob is re-synchronized.
• When a register is recalled that includes an off-limit Fader , the system brings the effect
back as a temporary “wipe limit.” You can use the AUTO TRANS button to complete
the transition.
Note
If this memory was stored with the Effects Dissolve feature activated,
and the AutoRcall option is set to
On
, the
CNTR
(
EFF D
) button will
be lit, and the current switcher setting will “slew” to the new recalled
setting.
Note
If this memory was stored with the Effects Dissolve feature activated,
and the AutoRcall option is set to
On
, the
CNTR
(
EFF D
) button will
be lit, and the current switcher setting will “slew” to the new recalled
setting.
Operating
Tip
If you want to recall more memories from the same bank you can use
the Quick Recall method.
E F F E C T S C O N T R O L M A T T E S S Y S T E M C O N T R O L
EDIT
SEL BACK MENU SEL CNTR
DVE
SEL
REV
5
0
6
1
7
2
8
3
9
100 10 1 4
MEM BKGD MEM2
0 2
Memory Bank