Ross Synergy 1, Maintenance Manual

Page: 50 / 240

3–4 • Software Upgrades Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
3. JP4, Panel Type
Jumper
JP4
works with
JP2
and
JP3
to set the control panel type. Refer to the
following table for details.
4. JP5, Reserved
Jumper JP5 is reserved for future use. Please leave it in the default Down position.
5. JP6, Reserved
Jumper JP6 is reserved for future use. Please leave it in the default Down position.
6. JP7, Reserved
Jumper JP7 is reserved for future use. Please leave it in the default Down position.
7. JP8, Reserved
Jumper JP8 is reserved for future use. Please leave it in the default Down position.
8. JP9, Panel Redundant Power
Jumper JP9 indicates whether or not redundant power has been installed in the control
panel.
• Up — Redundant power is installed. The red POWER FAIL indicator on the
control panel will light in the event of a power supply failure in the panel.
• Down — Redundant power is not installed. The red POWER FAIL indicator will
not light.
9. DIP Switch 1
This 8-position DIP switch is reserved for future use. Please leave all switches in the
default
Down position as labeled on the switch.
10. DIP Switch 2
This 8-position DIP switch is reserved for future use. Please leave all switches in the
default
Down position as labeled on the switch.
11. Reset Button
Press the control panel’s RESET button to initiate a full panel reset. When the reset is
initiated from the control panel, the frame’s reset is initiated using a software message
that is passed along the RS-422 control cable. In the unlikely event that the frame has
crashed, it may be necessary to
manually reset the frame. Refer to the section “ System
Reset Notes ”on page 3-7 for additional important information about the system reset
function.
Setting the Control Panel by Jumper Type
Jumper Synergy 1
JP2 Down
JP3 Down
JP4 Down