Ross Synergy 1, Maintenance Manual

Page: 204 / 240

12–2 • Synergy 1 Control Panel Options Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Installing the Routing Switcher Interface Option
This section provides general instructions for installing the Routing Switcher Interface Option ,
which adds routing switcher interface capability to your Synergy digital production switcher. You can
connect a number of Routers to your Synergy 1 switcher. The procedure for connecting the Router
will depend on the type of Router you have. For more information on setting up your device with the
Synergy switcher, refer to the
Synergy 1 Installation Guide .
Use the following procedure to install the Routing Switcher Interface Option :
1. Install the Routing Switcher Interface Option . Refer to the section “ Installing
Software Options – Synergy 1 ” on page 6-7 for instructions.
2. Ensure that one of the serial ports on your router is properly set up to communicate with
the Synergy 1 switcher.
3. Ensure that the serial ports on your router is properly connected to a remote port on the
Synergy 1 switcher. Refer to the documentation for your device to learn more on its
specific remote control communications port.
4. Ensure that you have set up a communications port on the Synergy 1 switcher for a
router. Refer to the section, “ Setting up the Switcher ” in the Synergy 1 Installation
Guide , for instructions.
5. Ensure that the desired BNC is configured for a router on the Synergy 1 switcher. Refer
to the section, “ Setting Up Router BNCs ” the Synergy 1 Installation Guide for
instructions.
This completes the procedure to install the Routing Switcher Interface Option .