Ross Synergy 1, Maintenance Manual

Page: 185 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16) Control Panel Boards • 10–13
Basic Interconnections – Synergy 100
This section describes the basic types of interconnections on the Synergy 100 control panel boards.
In the Synergy 100 panel, there are two 50-pin ribbon cables that run from the Display Board
(4100A-037) to the Pattern Switch Board (4100A-036), and then to the Panel CPU Board
(4100A-033).
The ribbon cable connectors are the same, but the orientation of each connector allows it to be
attached only in one place.
Notes on the Synergy 100 Basic Interconnections
Please note:
• The faders are connected through a 16-pin dip-style socketed connector, with an
indicator that shows the location of pin 1.
• The Positioner for the Synergy 100 panel connects with a 16-pin ribbon cable.
• The Interface Board (4100A-039) is connected using edge card fingers that are inserted
into connectors on the Panel CPU Board (4100A-033).
• The floppy drive is connected to the Interface Board (4100A-039) with a 26-pin ribbon
cable.
Important
Do not open the Synergy 100 control panel without express
instructions from Ross Video Technical Support.
Note A USB port replaces the floppy drive if you have the USB Removable
Media Drive option installed. The USB port connects to the Panel
CPU Board (4100A-033) with a 60-pin ribbon cable.