Ross Synergy 1, Maintenance Manual

Page: 147 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Calibration and Diagnostics • 9–5
2. To calibrate the fader:
• Press
0. Knob/Fader/Positioner Calibration
.
• Move the fader to its full upper and lower limit.
• Repeat this procedure two or three times.
As you move the fader, you will see a series of numbers appear in the four-character
displays in the
Effects Control and System Control groups.
• Calibration is complete when the limit values in these four-character displays no
longer change.
3. To calibrate the positioner, move each axis as follows:
• Ensure the
0. Knob/Fader/Positioner Calibration
option is selected.
• Calibrate the X-axis by moving the joystick all the way to the left then all the way to
the right. Repeat this procedure two or three times.
• Calibrate the Y-axis by moving the joystick all the way up then all the way down.
Repeat this procedure two or three times.
• Calibrate the Z-axis by twisting the joystick knob fully clockwise and
counterclockwise. Repeat this procedure two or three times.
As you move the joystick, you will see a series of numbers appear in the
four-character displays in the
Effects Control and System Control groups.
• Calibration is complete when the limit values in these four-character displays no
longer change.
4. To calibrate the knobs:
• Ensure the
0. Knob/Fader/Positioner Calibration
option is selected.
• Move each knob fully clockwise and counterclockwise.
• Repeat this procedure two or three times for each knob .
As you move the knobs, you will see a series of numbers appear in the
four-character displays
in the Effects Control and System Control groups.
• Calibration is complete when the limit values in these four-character displays no
longer change.
5. To adjust the brightness of all the LEDs on the control panel:
• Press
1. Overall LED Brightness Control
.
• Brightness is adjusted by rotating any of the knobs on the panel.
6. To adjust the brightness of the LEDs in the Ross logo in the upper right-hand corner of
the control panel:
• Press 2. Logo Brightness .
• Brightness is adjusted by rotating any of the knobs on the panel.
Note
The numbers for each axis may not match — this is normal.
Note
The numbers for each knob may not match — this is normal.