Ross Synergy 1, Maintenance Manual

Page: 145 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Calibration and Diagnostics • 9–3
4. To calibrate the knobs:
• Move each knob fully clockwise and counterclockwise.
• Repeat this procedure two or three times for each knob .
As you move the knobs, you will see a series of values appear in the Main Area , under
the KNOBS heading. The numbers for each knob may not match — this is normal.
5. At this point, you can complete the calibration or exit the menu safely without accepting
the calibration:
• To exit the menu safely, without accepting the newly calibrated controls, press
HOME
.
• To complete the calibration, press
Accept
.
This completes the procedure to calibrate the analog controls of the Synergy 1 switcher.
Note Any controls that were not touched during the calibration process will
display, “
Not Moved ”. These controls will retain their previous
calibration limits.
Caution When you press Accept , do not hold the positioner off center. This
will program a false “center” for the joystick, and you will have to
re-calibrate the switcher again to clear it.