Ross Synergy 1, Maintenance Manual

Page: 118 / 240

6–10 • Working with Installed Options Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Options Menu – Synergy 100
An Options Menu is available that allows you to verify all of the installed options in your Synergy
100 switcher. All menus are accessed in the Preview Overlay mode. Refer to the section, “ Using the
Menu System ” in your Synergy 100 Operation Guide , for complete instructions.
Refer to Appendix B of the Synergy 100 Installation Guide for all hardware installation instructions.
Using the Options Menu
The Options Menu lists the hardware options that have been installed in your switcher and allows
you to link to the Software Options Menu . Verify that all options ordered are installed. If not, contact
Ross Video Technical Support.
Use the following procedure to view the installed options for your Synergy 100 switcher:
1. Press
MENU
to display the Main Menu .
Synergy 100 Main Menu
2. Press 7. Options in the Effects Control Group to display the Options Menu .
Options Menu
Important
Serial numbers allow Ross Video to track which options have been
purchased by each customer. Serial numbers are installed in flash
memory at the factory.
Main Menu - Synergy 100
0. Effects
1. Inputs
2. Outputs
3. GPIs
4. Communication
vX.XX-S100
5. Disk
6. Personality
7. Options
8. S&T 3D
9. Default
MENU
Exit 100
Previous SEL
Accept 10
Down 1
Up
Options S/N:F422342234
0. Software Options
1. Opt Card Ultimatte
MENU
Exit
100
Previous
10
Down 1
Up SEL
Accept
2. S&T DVE 3D
3. Border
Yes
4. Tallies
16
5. Panel ID
6. Frame ID 4100-2
4216-4