Ross Synergy 1, Maintenance Manual

Page: 103 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) Frame Processor (CPU) Board • 5–7
Synergy 100 — Installation Warning
•
SW8
— Software Upgrade . This switch controls the ability to upgrade software
from a storage device:
~
Up — Software can be upgraded from a floppy disk or USB key. Refer to the
section “ Synergy 1 Software Upgrades ” on page 3–9 for upgrade instructions
for your Synergy 1 control panel. For information on upgrading the software
for your Synergy 100 control panel, refer to the section “
Synergy 100
Software Upgrade ” on page 3–19.
~ Down — Software can not be upgraded from a storage device. This is the
default position.
6. Watch Dog Jumper
Leave the
Watch Dog Jumper
in the default
DISABLE
(
Up
) position.
Note
Place the switch in the Up position when you want to restrict access to
installation menus. For certain facilities, this setting is recommended
once installation is complete.
WARNING!
You are about to change the switcher's
installation settings.
10
Down 1
Up SEL
Accept
0. Confirm
1. Cancel