Ross SRG-2200, User Manual

Page: 17 / 96

SRG-2200 User Guide (v6.0) Physical Installation • 17
Physical Installation
This chapter provides instructions for installing the SRG-2200.
Before You Begin
Before installing the SRG-2200, refer to the document “ Important Regulatory and Safety Notices to Service
Personnel ” that accompanied your unit for general safety information.
Static Discharge
Throughout this manual, please heed the following cautionary note:
Unpacking
Unpack each SRG-2200 you received from the shipping container and ensure that all items are included. If any
items are missing or damaged, contact your sales representative or Ross Video directly.
Initial Product Inspection
Perform the following Initial Product Inspection Procedure when you receive your SRG-2200:
1. Inspect the shipping carton for external damage, which may indicate possible damage to the SRG-2200. If
damage exists, document it, including photographs, to support any insurance claim.
2. Remove the instrument from the shipping carton.
3. Check that the SRG-2200 has not been damaged in transit. The exterior should not have any scratches or
impact marks. Prior to shipment the SRG-2200 is thoroughly inspected for mechanical defects.
4. Verify that the shipping carton contains the instrument, the standard accessories, and any optional accessories
that you ordered.
5. Perform the Functional Check Procedures as outlined in the chapter “ Functional Check Procedures ” on
page 21 after installing the SRG-2200.
 Save the shipping carton and packaging materials for SRG-2200 re-packaging in case return shipment becomes
necessary.
Operating Environment Requirements
Verify that the location of your installation has the proper operating environment. The SRG-2200 operates correctly
in ambient temperatures from 0°C to +40°C and relative humidity from 20% to 80%.
For More Information on...
• environmental operating specifications, refer to the appendix “ Specifications ” on page 59.
The SRG-2200 requires 50mm (2”) of side clearance for counter top use. Also, ensure sufficient rear clearance, e.g.
75mm (3”), so that cables are not compromised.
ESD Susceptibility
— Static discharge can cause serious damage to sensitive semiconductor
devices. Avoid handling circuit boards in high static environments such as carpeted areas and when
synthetic fiber clothing is worn. Always exercise proper grounding precautions when working on circuit
boards and related equipment.