Ross Opengear UDC-8625A Series, User Manual, Page: 83 / 174

UDC-8625A Series User Manual (Iss. 11) Audio Configuration • 6–5
Setting up the Embedded Audio
The Embedded Audio tabs includes options for enabling sample rate conversion (SRC) of the
embedded audio, enabling audio fading, configuring how audio is embedded for SD outputs, and
channel mapping. There are two Embedded Audio tabs in DashBoard:
• The Embedded Audio Processing tab provides options for processing the incoming
embedded audio (Input 1 and/or Input 2).
• The Embedded Audio Selection tab provides options for overriding embedded audio
with AES for one or both inputs, and to shuffle the embedded channels.
This section briefly outlines how to configure the options in the Embedded Audio tabs.
For More Information on...
• the options in the Embedded Audio Processing tab, refer to Table 9.15 on page 9-20.
• the options in the Embedded Audio Selection tab, refer to Table 9.16 on page 9-21.
• alarm options for embedded audio, refer to Table 9.25 on page 9-34.
Processing the Embedded Audio Input
When passing non-PCM data (e.g. Dolby E®), ensure that input and output are synchronous and
all audio modifying settings (such as SRC, gain, and invert) are disabled or set to zero (0).
To set up processing of the embedded audio input
1. From the Device View , select the Embedded Audio Processing tab.
Embedded Audio Processing Tab — Input 1 Selected
2. From the Embedded Audio Processing tab, select the sub-tab for the input source you
wish to process.
3. To enable the SRC of the embedded audio, toggle the Sample Rate Conversion to
On .