Ross Opengear UDC-8625A Series, User Manual, Page: 48 / 174

3–8 • Configuration UDC-8625A Series User Manual (Iss. 11)
To set up GPI/Tally communications
1. From the Device View in DashBoard, select the Config tab.
2. Select the GPI/Tally tab located at the bottom of the Config tab.
Config Tab — GPI/Tally Tab
3. To configure a port as a GPI:
• Assign a transition event to a GPI by selecting an option from the Function field
next to the GPI in the GPI/Tally area. Refer to Table 9.6 on page 9-9 for a list of
options.
• Select a trigger for the GPI from the Trigger column.
• Select a polarity for the GPI from the Polarity column.
4. To configure a port as a Tally:
• Select what will drive the tally output when the input is on-air by selecting the
function next to the Tally in the GPI/Tally area. Refer to Table 9.7 on page 9-10 for
a list of options.
• Select the polarity of the tally from the Polarity column.
Note
— The 8320AR-041 rear module does not include GPI/O ports. You can still
configure the settings in the GPI/Tally tab, but your changes will not take effect.