TSI-100 User Guide (v5.0)
Physical Installation • 19
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back plane of the frame. Do
not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with Rear Modules or Blank
Plates.
Installing the TSI-100
To install the TSI-100 in an openGear frame
1. Locate the Rear Module you installed in the procedure “
2. Hold the TSI-100 by the edges and carefully align the card-edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plus is properly seated in the Rear Module.
4. Verify whether your rear module label is self-adhesive by checking the back of the label for a thin wax sheet.
You must remove this wax sheet before affixing the label.
5. Affix the supplied rear module label to the BNC area of the Rear Module.
Notice
— Heat and power distribution requirements within a frame may dictate specific slot placements
of cards. Cards with many heat-producing components should be arranged to avoid areas of excess
heat build-up, particularly in frames using convectional cooling.
Screw Hole
Module Seating Slots
