Ross Opengear FED-6943, User Manual, Page: 79 / 92

Fiber Ethernet Switch Transceivers User Manual (Iss. 04) Configuration • 9–13
4.
To monitor the optical receiver power consumption of the card, select the applicable RX
Power High and Rx Power Low check boxes to enable the card to report when the
receiver power is not within the recommended range for the SFPs.
To enable temperature monitoring
1.
From the Device View , select the Alarm Enable tab.
2.
Select the Enable Fiber Abnormal Temperature check box for the fiber optic
connection you wish to monitor.
Incompatible Rear Module Monitoring
You can choose to enable the card to report when an unsupported rear module is installed with
your card. This alarm is reported in the
HW Status field in the Hardware tab.
To enable rear module monitoring
1.
From the Device View , select the Alarm Enable tab.
2.
Select the Incompatible Rear Module check box.