Ross openGear ADA-8402-A, User Manual

Page: 23 / 36

ADA-8402-B User Manual (Iss. 04) User Controls • 3–3
Configuring the DIP Switches
This section provides a brief summary of the DIP Switches of the ADA-8402-B. Figure 3.4
shows all the DIP Switches in the OFF position.
Figure 3.4 DIP Switches — OFF Positions
Enabling Card-edge Control
SW1 and SW2 are used in conjunction to enable/disable the card-edge DIP Switches to change
settings on the card. You can still monitor the card status in DashBoard. Table 3.2 lists the
combinations of DIP Switch settings for SW3 and SW4 .
Setting the Output Mode
SW3 and SW4 , are used in conjunction to set the output mode of the ADA-8402-B. Table 3.2
lists the combinations of DIP Switch settings for SW3 and SW4 .
Specifying the Gain
SW6 - SW10 are used in conjunction to specify the coarse level gain adjustment applied to the
output of the ADA-8402-B. Table 3.3 lists the combinations of DIP Switch settings for
SW6 - SW10 .
Table 3.1 Setting the Card-edge Control
SW1 SW2 Description
OFF OFF Control is from DashBoard only.
The DIP switch settings are ignored.
This is the default setting.
OFF ON Not implemented. Do not use.
ON OFF Not implemented. Do not use.
ON ON DashBoard control is disabled.
The DIP switch settings are applied.
Table 3.2 Setting the Output Mode
SW3 SW4 Mode Selected
OFF OFF Stereo
OFF ON Mono
ON OFF Left Only
ON ON Right Only
1 2 3 4 5 6 7 8 9
O N
10