Ross NWE-TS, User Manual, Page: 43 / 68

NWE-TS User Manual (Iss. 01) DashBoard Menus • 4–3
Status Tab
Table 4.2 summarizes the read-only information displayed in the Status tab.
Table 4.2 Status Tab Items
Tab Title Item Parameters Description
Status
TX
(Green)
Indicates the NWE-TS is producing a
valid ASI Output
(Red)
Indicates the ASI output of the NWE-TS
is invalid
RX
(Green)
Indicates a valid ASI input signal is
connected to the ASI IN BNC of the
NWE-TS
(Red)
Indicates the input signal connected to the
ASI IN BNC is invalid or missing
Encode
(Green)
Indicates the NWE-TS is watermarking
the audio signals
(Red)
Indicates that no watermarking is
occurring
Alarm
(Green)
Indicates that the NWE-TS is operating
correctly with no errors
(Red)
Indicates that a serious error condition has
occurred in the last few seconds. Refer to
the Event Log tab for additional
information.
Warning
OK (Green)
NWE-TS is not experiencing any error
conditions
# (Yellow)
NWE-TS has experienced a minor error
condition in the last few seconds
System Mode
Active (Green)
Indicates the ASI signal is routed through
the NWE-TS
Switched Bypass (Red)
Bypass mode set
via the Bypass
Mode button on the
front panel
Indicates the ASI
signal on the ASI
IN BNC is looped
passively to the
ASI OUT BNC
through the relays
User Bypass (Red)
Bypass mode set
using DashBoard
PSIP Present
Yes (Green)
PSIP Tables are present in the incoming
Transport Stream (TS)
PSIP Not Preset (Red) PSIP Tables are absent in the incoming TS
PSI Present
Yes (Green) PSI Tables are present in the incoming TS
PSI Not Present (Red) PSI Tables are absent in the incoming TS
PSIP PSI Match
Yes (Green)
Revision levels in the PSI Tables match
the levels in the PSIP Tables
PSIP Not Matching (Red) The levels are mis-matched or missing