NWE-TS User Manual (Iss. 01)
Configuration • 3–7
Configuring the NWE-TS
This section outlines additional communication setup such as setting the audio code scheme for
the NWE-TS, and using the Bypass buttons on the Configuration tab.
Setting the Code Level
You must specify the NWE-TS role in your program path.
To set the code level for a NWE-TS
1.
Select the
NWE-TS
node in the Tree View of the NWE-TS you want to configure.
2.
Select the
Configuration
tab in the Device View.
3.
Set the audio code scheme for your NWE-TS by selecting an option in the
SID Code
Level
menu. Choose from the following:
•
Final Distributor
— Select this option if the NWE-TS is installed in the station or
cable network slot of the program-distribution chain.
•
Program Content
— Select this option if the NWE-TS is installed in the broadcast
network or syndicator slot of the program-distribution chain
.
4.
Click
Set
beside the
SID Code Level
menu to apply your changes.
Setting the Transport Stream ID
A TSID value is assigned to each emitter of an ATSC signal. The NWE-TS compares the value in
the incoming stream to the one specified here. If they do not match, watermarking is disabled. To
disable this comparison and accept any ATSC TS input, enter the value 0.
To set the System TSID for your NWE-TS
1.
Select the
NWE-TS
node in the Tree View of the NWE-TS you want to configure.
2.
Select the
Configuration
tab in the Device View.
3.
In the
System TSID
field, type the identification number for the incoming transport
stream for your NWE-TS.
4.
Click
Set
beside the
System TSID
menu to apply your changes.
Using the Bypass Mode
In this mode, the ASI input is re-clocked and routed to the ASI output without any watermarking
or delay. This will occur if the NWE-TS is unable to process the ASI TS for some reason, or
under DashBoard control. In this mode, the Encode LED on the front panel is off. This section
outlines how to enable Bypass mode using DashBoard.
Note
— This software-controlled bypass mode does not operate the same way as the front
panel BYPASS button. When the button is in the Bypass (out) position, the ASI input BNC is
looped passively to the ASI output BNC through a relay, and the input is not available for
inspection by the NWE-TS software. The BYPASS LED on the front panel is lit red, and the
main DashBoard status for the NWE-TS indicates
Bypass
.
Summary of Contents for NWE-TS
