NK-IPS Installation Guide (v5.0)
Using an NK-VCP • 31
Using an NK-VCP
The NK Virtual Control Panel (NK-VCP) is a software application that communicates via the NK-IPS and enables
monitoring and control of the router matrix. If required, it is also possible to control multiple systems, alternating
between each as needed.
As the NK-VCP works in conjunction with the NK-IPS, NK-VCP control can be password protected to only allow
authorized users to perform router functions.
Figure 7.1 Example of the NK Virtual Control Panel
Although the NK-VCP will operate with Java Runtime Environment 1.4.2 and later, it is recommended that users
have the latest JRE installed on their computer before using the NK-VCP.
Installing the NK-VCP
The NK-VCP runs in the Java® platform, using version 1.4.2 or later of the Java Runtime Environment (JRE). This
allows the application to run on any system that supports the Java Virtual Machine (VM). The program runs on
Microsoft® Windows®.
To use the NK-VCP, the Java Runtime Environment must first be present on your system. If this software is not
present on your system, or if you are unsure, follow the guidelines below to ascertain whether it needs to be
installed or updated.
NK-VCP is only supported Microsoft® Windows® based operating systems and will launch in 32-bit
environments only.
System Requirements
• Intel® Pentium® 200Mhz or equivalent
• Microsoft® Windows® XP or later
• 32MB of RAM
• 150MB of available hard-disk space
Installing the Java Runtime Environment (JRE)
The Java Runtime Environment is required for NK-VCP operation. If you are unsure what version (if any) of the
JRE is installed on your computer, you will need to open a command line prompt.