Ross nielsen NWE-IP, User Manual, Page: 21 / 80

NWE-IP User Guide (v5.0) Physical Installation • 21
Physical Installation
This chapter provides additional information for installing the NWE-IP, and DashBoard before you can proceed to
cabling and configuring your NWE-IP.
Installing the NWE-IP in a Rack Frame
Refer to the NWE-IP Quick Start Guide that accompanied your device and its mounting kit for installation
information.
Connecting the Power Supplies
For redundancy, each power cord should be connected to a separate power source for protection against failure of
the A/C power circuit. In the event of one power supply failure, the frame load is transferred to the other redundant
power supply.
The power supply plugs into the right-hand section of the NWE-IP rear panel. The universal power supply supports
all worldwide AC power voltages, and no power adjustments are required.
To connect the NWE-IP to the power supplies
1. Connect the cable’s female IEC connector to the right power socket.
2. Plug the second IEC connector into left power socket.
3. Each AC connector includes a Power-Lock, which is designed to retain the power cable connector. Clip the
Power-Lock over the shoulder of the inserted AC Cable end.
4. Connect each supplied power cable’s three-prong male connector to an AC outlet.
5. Power on the NWE-IP by pressing the
POWER
button on the front panel. Refer to “
Front Panel Overview
” on
page 19 for the location of this button.

The fans run at full speed for a short period at the startup.
Warning
— In some countries, it may be necessary to supply the correct mains supply cord. Use only
an approved IEC 320 C-13 type A/C line cord rated for a minimum 10A at 250V and certified for the
country of use.
Warning Hazardous Voltages
— The safe operation of this product requires that a protective
earth connection be provided. This protective earth is provided by the grounding conductor in the
equipment’s supply cord. To reduce the risk of electrical shock to operator and service personnel, this
ground conductor must be connected to an earthed ground.
Gb 1 Gb 2
To Power Source 2 To Power Source 1