Ross DRA-8204, User Manual

Page: 25 / 40

DRA-8204 User Manual (Iss. 05) User Controls • 3–7
Reclocker Rate Selection
This section describes the Reclocker Rate Selection button and LEDs. Refer to Figure 3.3 for
button and LED locations.
Reclocker Rate Selection LEDs
Table 3.3 provides status information on the Rate Selection button and LED functions. For
example, if the AUTO and BYPASS LEDs are both lit, the card is configured for Bypass mode.
= Illuminated LED
Table 3.3 Rate Selection and LED Functions
Date Rate LED Displays
Description
AUTO OTHER 143 177 270 360 540 1485
Cycling through LEDs
Channel searching incoming
signal for a valid data rate (default
setting).
Auto mode, channel detects and
reclocks 143Mbps.
Auto mode, channel detects and
reclocks 270Mbps.
Auto mode, channel detects and
reclocks 360Mbps.
Auto mode, channel detects and
reclocks 540Mbps.
Auto mode, channel detects and
reclocks 1.485Gbps.
Channel set to reclock 143Mbps.
Channel set to reclock 177Mbps.
Channel set to reclock 270Mbps.
Channel set to reclock 360Mbps.
Channel set to reclock 540Mbps.
Channel set to reclock 1.485Gbps.
Channel equalizes (but does not
reclock) any SDI signal from
143Mbps to 1.485Gbps.