Ross DRA-8204, User Manual

Page: 15 / 40

DRA-8204 User Manual (Iss. 05) Installation • 2–3
Installing the DRA-8204
This section outlines how to install a Rear Module and the DRA-8204 in a DFR-8300 series
frame.
Rear Modules for the DRA-8204
The following rear module are required when installing the DRA-8204:
• DFR-8310 series frames — The DRA-8204 requires the 8310AR-030 Rear Module
(R1-8204), and is also compatible with the DFR-8310-BNC frame.
• DFR-8321 series frames — The DRA-8204 requires the 8320AR-030 Full Rear Module
(R2-8204).
Installing a Rear Module
If you are installing the DRA-8204 in an DFR-8310-BNC frame, or the rear module is already
present, skip this section
Use the following procedure to install a Rear Module in a DFR-8300 series frame:
1. Refer to the DFR-8300 Series User Manual to ensure that the frame is properly
installed according to instructions.
2. Locate the card frame slot on the rear of the frame.
3. Seat the bottom of the Rear Module in the seating slot at the base of the frame’s back
plane.
Figure 2.1 Rear Module Installation (DRA-8204 not shown)
4. Align the top hole of the Rear Module with the screw hole on the top edge of the frame
back plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the frame
back plane. Do not over tighten.
This completes the procedure for installing the RM-8300-B in an 8300 series frame.