Ross ASI-310, User Manual

Page: 21 / 34

ASI-310 User Guide (v5.0) Physical Installation • 21
Installing the ASI-310 in an openGear Frame Slot
To install the ASI-310 card in an openGear frame
1. Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on page 20.
2. Hold the ASI-310 by the edges and carefully align the card-edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plus is properly seated in the Rear Module.
4. Verify whether your label is self-adhesive by checking the back of the label for a thin wax sheet. You must
remove this wax sheet before affixing the label.
5. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
Notice
— Heat and power distribution requirements within a frame may dictate specific slot placements
of cards. Cards with many heat-producing components should be arranged to avoid areas of excess
heat build-up, particularly in frames using convectional cooling.