RosRoca Dennis Eagle Olympus, Service Manual, Page: 33 / 104

3
3‑9
DAILY CHECKS
OL1D-SM-GB02D
37. Press the eject switch. Release the switch when the
ejection plate has reached the end of its travel.
2847-OL1-D-GB-G2
0 No errors
0 No errors
0 No errors
Hyd Oil Temp
0 No errors
0 No errors
32 o C
01.06.2013 09:00:00
Hyd_Oil_Pressure 60 Bar
2
• Ejection plate should eject smoothly without
judder.
38. Press the retract switch. Release the switch when
the ejection plate has reached the end of its travel.
2848-OL1-D-GB-G2
0 No errors
0 No errors
0 No errors
Hyd Oil Temp
0 No errors
0 No errors
32 o C
01.06.2013 09:00:00
Hyd_Oil_Pressure 210 Bar
2
• Ejection plate should retract smoothly without
judder.
• The body full pictogram should display on the
cab control panel screen.
• Immediately the tailgate reaches full height,
the compaction mechanism should complete
the number of full cycles shown by the white
number in the tip clear pictogram, i.e. packer
plate open, carriage plate down, packer
plate close and then carriage plate up, in one
continuous sequence until fully packed when it
should stop.
WARNINGS:
MAKE SURE THAT YOU KNOW THE HEIGHT
OF YOUR VEHICLE WITH THE TAILGATE
AND WASTE CONTAINER LIFTING DEVICE,
IF FITTED, RAISED.
DRIVER MUST BE IN CAB.
PARKING BRAKE MUST BE APPLIED.
ALL PERSONNEL MUST BE CLEAR OF
FRONT AND REAR OF VEHICLE.
VEHICLE MAY LURCH FORWARDS.
35. Firmly apply the footbrake. Then select Drive ‘D’.
• ‘Tailgate out‑of‑locks’ warning buzzer in the
cab should sound immediately Drive ‘D’ is
selected.
36. Select Neutral ‘N’.
• ‘Tailgate out‑of‑locks’ warning buzzer in the
cab should silence immediately Neutral ‘N’ is
selected.