Rose electronics UltraLink E Series, Installation And Operation Manual

Page: 53 / 68

UltraLink E-Series Manual 46
Safety
The UltraLink E-Series product, like all electronic equipment, should be used with care. To protect yourself
from possible injury and to minimize the risk of damage to the Unit, read and follow these safety
instructions and also review your warranty for more information.

Follow all instructions and warnings marked on the products.
 Except where explained in this manual, do not attempt to service the products yourself.

Do not use the products near water.

Assure that the placement of the products is on a stable surface.
 Provide proper ventilation and air circulation.

Keep connection cables clear of obstructions that might cause damage to them.

Use only power cords, power adapter and connection cables designed for the products.
 Keep objects that might damage the products and liquids that may spill, clear from the products.
Liquids and foreign objects might come in contact with voltage points that could create a risk of fire
or electrical shock.
 Do not use liquid or aerosol cleaners to clean the products. Always unplug the products from the
power source before cleaning.
Don’t attempt to open or repair a power supply unit. Remove power from the Unit and refer servicing to a
qualified service center if any of the following conditions occur:
 The connection cables are damaged or frayed.

The Unit has been exposed to any liquids.

The Unit does not operate normally when all operating instructions have been followed.
 The Unit has been dropped or the case has been damaged.

The Unit exhibits a distinct change in performance, indicating a need for service.
Safety – Installation and operation

Read and retain all instructions. Only use your product according to the instructions, operating
ranges, and guidelines provided in the product user guide. Failure to follow these instructions could
result in damage to your product or injury to the user or installer.

Don’t expose your product to rain, water, condensation, or moisture.

Your product (card or appliance) can become hot while operating. Always turn off your computer,
unplug it, and then wait for it to cool before touching any of the internal parts of your computer or
installing your PCIe card. Allow hot surfaces to cool before touching your product.

Static electricity can severely damage electronic parts. Before touching any electronic parts, drain
static electricity from your body (for example, by touching the metal frame of your computer).

When handling a card, carefully hold it by its edges and avoid touching its circuitry.

Don’t stack devices or place devices so close together that they’re subject to recirculated or
preheated air.

Don’t operate your system or product near a heat source or restrict airflow to your system, and
make sure the ambient temperature doesn’t exceed the maximum recommended temperatures.
Don’t block ventilation holes on your unit or system.