Rose electronics UltraLink E Series, Installation And Operation Manual

Page: 49 / 68

UltraLink E-Series Manual 42
3. Using automatic detection
To search for devices on your subnet, using Automatic detection, click Search.
Wait while the Updater finds the devices and answer the authentication dialog detailed in step 5.
If the devices are present on your subnet, then all devices should be found. If your network is
more complicated than a simple subnet you may need to use the manual detection method in step
4.
4. Using manual detection
If devices aren’t automatically detected, you can manually locate one or more devices using their
IP addresses. Select Manual detection , and below Address or URL enter the IP address of each
device you want to locate.
If you’re entering multiple addresses, separate each address with a space. You can also enter the
addresses or URLs by click the browse button and clicking one IP address per line. When you’re
done entering the addresses or URLs, click Apply . To discard the last changes made, click Cancel .
To start searching, click Search. Wait while the Updater finds the devices and answer the
authentication dialog in step 5
5. Authenticate the devices found
If you provided a password for the UltraLink E-series devices, you may be prompted to
authenticate the devices found.

If you’re prompted, enter your credentials for the devices found:
• Local user – Enter your user name and password.
•
Domain user – Enter your user name, the domain name of the server, and
your network password.
Local user Domain user
Figure 38. Update firmware – Authentication dialog for devices with a password