UltraLink E-Series Manual
22
Setting up point-to-point mode
1.
Install any transmitter cards in the PC case.
2.
Connect all of the cables including the network cable from the transmitter to the receiver and
power up the UltraLink devices from their front power switches.
3.
Using the Receiver OSD, enable point-to-point mode.
4.
Optionally configure the transmitter and receiver units through the OSD.
When using your devices fresh out of the box and setting them up for the first time for point-to-point
mode, the on-screen display (OSD) on the receiver device shows an initial screen which indicates point-to-
point mode is not enabled. This animation repeats for about six times and then is followed by the
Select
the operation mode
screen. Using the mouse attached to the receiver, click on Enable Point-to-Point. After
a few seconds of configuration and possible brief messages of Synchronizing and Connected to …, you
should see the video from the computer attached to the transmitter. This procedure is a one-time setup.
Figure 24. Screen showing initial point-to-point mode not enabled
I
Figure 25. Screen showing select operation mode for enabling point-to-point mode
Summary of Contents for UltraLink E Series
Page 7: ......