UltraLink E-Series Manual
13
Reset switch for rebooting or configuration reset
Warning:
A configuration reset restores the default settings of the UltraLink E-Series device. This resets
all of the device settings, including the IP configuration and password.
Warning:
Point-to-point mode
– Performing a configuration reset on a Receiver also resets the
configuration of the connected Transmitter.
PCIe Transmitter Card – Reset switch
For the PCIE transmitter card, since this switch is not accessible when the PC has been closed, it is
recommended that you understand its significance in programming point-to-point mode. If you intend for
the transmitter to operate in networked mode, then do not program the product for point-to-point. Once
point-to-point mode is programmed the only way to return it to networked mode is by using this switch.
Hardware reboot
– Press the
Reset
button for one second (the front panel LED turns slow blinking
green) to reboot the device.
Configuration reset
– Press and hold the
Reset
button for about 5 seconds (until the front panel LED
turns fast blinking green) to reboot the device and restore default settings.
Figure 10. PCIe card – reset switch
Transmitter and Receiver Appliance – Reset switch
Hardware reboot
– Press the recessed
Reset
button with the tip of a paper clip for one second (the
power LED turns slow blinking green) to reboot the device.
Configuration reset
– Press and hold the recessed
Reset
button with the tip of a paper clip for about 5
seconds (until the power LED turns fast blinking green) to reboot the device and restore default settings.
Figure 11. Transmitter and Receiver Appliance – reset switch
Summary of Contents for UltraLink E Series
Page 7: ......
