Parts
Instructions for Hanging
Step 1
When using QuickGrip to hang 1/8” Sintra
or an equally heavy substrate, have your
printer punch two 1/4” holes along the top
and bottom edges of print — or only the top
if no bottom holder is being used.
Fig. 1
Note:
Each hole must be centered 1/4” in
from the edge of the substrate.
Step 2
Push both parts of the peg together through
each of the punched holes.
Fig. 2
Step 3
Slide QuickGrip onto substrate. The pegs
should slide into the side rails.
Fig. 3
Note:
This is the easiest way to safely hang
heavier substrates.
Step 4
Squeeze sides of MultiClip together.
Fig. 4
Align the bottom rail of the MultiClip with
the top channel of the plastic holder. Slide
MultiClip into rail.
Fig. 5
Repeat step 3
for second MultiClip.
Step 5
Push end caps into place.
Fig. 6
Step 6
Suspend poster.
Fig. 7
End Caps
06-5525
Incept-3.11.03
QuickGrip is a trademark of Rose Displays, Ltd. Neither the manufacturer
nor any sales agent may be held liable for injury, loss or damage resulting
from the use of these products.
Part #03INSQuickGripPegMC
QuickGrip
12-0500
Figure 7
Figure 6
Figure 3
Figure 2
Figure 1
Multiclips
1UP-0101
Figure 4
35 Congress Street, Salem, MA 01945
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
Pegs
06-1920
Figure 5
Instruction Sheet
QuickGrip™ with Peg
