The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSGotchaWindowMounts
Incep 9/16/02
Parts
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
Instructions for Hanging
Figure 1
Gotcha
®
Instruction Sheet
Window Mounts
20-0038
Step 1
Place poster on a flat surface. Snap the Gotcha
(top and bottom) open so hinge is turned up as
far as possible. Insert graphic completely into
holder until edge of graphic meets top of holder.
To close, snap the Gotcha shut.
Fig. 1
Note:
It is easier to open and close the Gotcha
by starting at one end and working your way
down the holder. With large or curling graphics,
it may be easier to insert graphic at one end and
slide into holder from one end to another.
Step 2
Attach the Window Mounts to the Gotcha. You
should hear a “Snap” when the clip is properly
seated.
Fig. 2
Note:
For best results, place the suction cup clips
1/3 of the way in from each end on the top
holder.
Step 3
Prepare the window and suction cups by making
sure they are clean and free of dust and dirt.
Press the suction cups firmly to the window.
Gotcha
®
12G100
Figure 2
Important Note:
For best performance when first applied
and occasionally thereafter, press the
middle of the cup (on the cap) to “burp”
