35 Congress Street, Salem, MA 01945
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
Parts
Instructions for Hanging
Instruction Sheet
Step 1
When using AnoQuick to hang 1/8” Sintra or an
equally heavy substrate, have your printer punch
two 1/4” holes along the top and bottom edges of
print — or only the top if no bottom holder is
being used.
Fig. 1
Note:
Each hole must be centered 1/4” in from the
edge of the substrate.
Step 2
Push both parts of the peg together through each
of the punched holes.
Fig. 2
Step 3
Slide AnoQuick onto substrate. The pegs should
slide into the side rails.
Fig. 3
Note:
This is the easiest way to safely hang
heavier substrates.
Pegs
06-1920
AnoQuick™ with Peg
Instructions for Hanging
Incept-9.9.02
Figure 1
AnoQuick
12A300
The AnoQuick is a trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part # 02INSAnoQuickPeg
Figure 2
Figure 3
