Parts
Instructions for Hanging
Instruction Sheet
Step 1
When using AnoQuick to hang 1/8” Sintra or an
equally heavy substrate, have your printer punch
two 1/4” holes along the top and bottom edges of
print — or only the top if no bottom holder is
being used.
Fig. 1
Note:
Each hole must be centered 1/4” in from the
edge of the substrate.
Step 2
Push both parts of the peg together through each
of the punched holes.
Fig. 2
Step 3
Install MultiClip in the top AnoQuick Holder.
Holding clip at slight angle, first insert one round
end, then press down on other round end and push
MultiClip into holder.
Fig. 3
Note:
For OneUp applications place the
MultiClip in the center of the AnoQuick Holder.
AnoQuick™ with Peg
Instructions for Hanging
Incept-8.15.02
Figure 1
The AnoQuick is a registered trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part # 02INSAnoQw/PegMCEndcap
Figure 2
Figure 3
AnoQuick
12A300R
End Caps
06-5525
MultiClip
1UP-0100
Pegs
06-1920
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
