Page 9
© ROPOX 2019
6.2
Mounting of safety strip
Option: Ropox always recommends the use of safety strips on electrically
adjustable frames.
See the manual for strips provided.
Be careful not to damage the safety strip during transportation or mounting.
If the safety strip is bent or twisted too much it may not have the intended effect.
In order to obtain optimum adhesion the surface on which the safety strip is to be attached must
be clean and dry.
6.1.9 Fasten the tabletop with screws through the
holes of the fascias.
6.1.8 Place the frame on the table top and push
the cover plates between legs and table top.
Centre the frame in relation to the table top.
6.1.11 Connection to control unit
6.1.10 Mounting of fixed control switch
Pull the cable through the front
fascia and insert it into the control
unit.
6.2.1
Push the safety strip through all four legs
and fit it on the underside of the fascia by
means of the double-adhesive tape
provided.
Remove the protection paper of the tape
and press on the safety strip. Observe the
minimum bending radius (2cm inside)
See separate instructions for mounting
and handling of the safety strip.
Motor cabel M1
Motor cabel M2
Adapter cable
for safety strip
mains cable
Cable for control
switch
Safety strip (Options)
