Ropex RESISTRON RES-5009, User Manual, Page: 88 / 98

ROPEX CAN
Page 88 RES-5009 Version 1
11.6.2 Acknowledgement message
After each START/STOP command, the RESISTRON
®
Temperature Controller RES-5009 automatically sends
an acknowledgement message (CAN message address 0009). It contains the current actual value and the most
important status information:
11.6.3 Alarm /AUTOCAL status
Bit no. Name Meaning
0…8 Actual value Value of the current actual value (in °C)
9 Prefix Prefix of the actual value. 0: positive, 1: negative
10…11 Setpoint no. Number of the last setpoint used (0…3)
12 Control active 0: Measurement mode
1: Control mode
13 “Temperature
OK“ bit
0: Actual value is outside the specified temperature monitoring band
1: Actual value is inside the specified temperature monitoring band
14 Alarm 0: no alarm
1: Alarm active
15 Autocal blocked 0: AUTOCAL function possible
1: AUTOCAL function not possible (cooling off phase)
Bit no. Name Meaning
0…9 Error code three-digit error code
10…11 Error action 0: Perform RESET
1: Perform AUTOCAL
2: Check configuration
12…15 Autocal status 0: AUTOCAL function possible (not active and not blocked)
1: AUTOCAL function is active
2: Check for falling actual value
3: Wait until AUTOCAL request is withdrawn
4: Wait whether AUTOCOMP will be started
5: AUTOCOMP function active
6: AUTOCAL function blocked, because heating band is still warm
7: AUTOCAL function blocked, because test mode is active
8: AUTOCAL function blocked, because START is active
9: AUTOCAL function blocked, because PREHEAT is active
10: AUTOCAL function blocked, because DETACH is active (not used)
11: AUTOCAL function blocked, because RESET is active
12: AUTOCAL function blocked, because Alarm is active
13: reserved
14: AUTOCAL function is aborted