Technical data
Version 1
RES-5006
Page 57
Heating element type
and temperature
range
Besides setting through the rotary encoder switch or the PROFIBUS interface
(see below), the setting for the temperature range and temperature coefficient can
be performed through the ROPEX visualisation software (
interface for visualisation software ROPEXvisual
Temperature range:
200 °C, 300 °C, 400 °C or 500 °C
Temperature coefficient: 400…4000 ppm/K (variable setting range)
Five areas can be set over rotary coding switches or PROFIBUS interface:
Temperature coefficient 1100 ppm/K, 0…300 °C (e.g. alloy A20)
Temperature coefficient 780 ppm/K, 0…300 °C (e.g. alloy L)
Temperature coefficient 1100 ppm/K, 0…500 °C (e.g. alloy A20)
Temperature coefficient 780 ppm/K, 0…500 °C (e.g. alloy L)
Temperature coefficient 3500 ppm/K, 0…300 °C
Please take the necessary setting from the ROPEX application report
Analogue output
(Actual value)
Terminal 17+18
0…10 VDC, I
max
= 5 mA
corresponding to 0…300 °C or 0…500 °C
Precision: ±1% plus 50 mV
Alarm relay
Terminals 12, 13, 14
U
max
= 30 V (DC/AC), I
max
= 0.2 A, changeover contact, voltage-free
Power loss
Max. 20 W
Ambient conditions
Maximum altitude 2000 m
Ambient temperature: +5…+45 °C
Maximum relative humidity: 80% at temperatures up to +31 °C, decreasing line-
arly to 50% relative humidity at +45 °C.
Degree of protection
IP 20
Mounting
If several devices are mounted on a hat rail, a min-
imum distance of 20 mm must be maintained.
When mounting on a horizontal top hat rail, the
movable latch, which is necessary for fastening,
must face downward.
When mounting on a vertical top hat rail, end
holders must be installed on both sides to fasten the controller mechanically.
Weight
Approx. 0,7 kg (incl. plug-in connector parts)
Housing material
Plastic, polycarbonate, UL-94-V0
Connecting cable
Type / cross-sections
Rigid or flexible; 0.2…2.5 mm² (AWG 24…12) through pluggable terminals
Pluggable terminals: Tightening torque: 0.5…0.6 Nm
(Screwdriver: SZS 0.6x3.5 mm)
If ferrules are used, they must be crimped in accordance with DIN
46228 and IEC/EN 60947-1. Otherwise, correct electrical contact in the
terminals is not guaranteed.
20
!
