Ronde & Schwarz 1304.0004K03, User Manual

Page: 777 / 1071

Remote Commands
R&S
®
FPL1000
777 User Manual 1178.3370.02 ─ 11
Parameters:
<DelayTime> Range: 0 s to 30 s
*RST: 0 s
Default unit: S
Example: SWE:EGAT:HOLD 100us
Manual operation: See "Gate Delay" on page 345
[SENSe:]SWEep:EGATe:LENGth <GateLength>
This command defines the gate length.
Parameters:
<GateLength> Range: 125 ns to 30 s
*RST: 400μs
Default unit: S
Example: SWE:EGAT:LENG 10ms
Manual operation: See "Gate Length" on page 345
[SENSe:]SWEep:EGATe:POLarity <Polarity>
This command selects the polarity of an external gate signal.
The setting applies both to the edge of an edge-triggered signal and the level of a
level-triggered signal.
Parameters:
<Polarity> POSitive | NEGative
*RST:
POSitive
Example: SWE:EGAT:POL POS
Manual operation: See "Slope" on page 342
[SENSe:]SWEep:EGATe:SOURce <Source>
This command selects the signal source for gated measurements.
If an IF power signal is used, the gate is opened as soon as a signal at > -20 dBm is
detected within the IF path bandwidth (10 MHz).
For more information see "Trigger Source" on page 339.
Parameters:
<Source> EXTernal | IFPower | TIME
*RST:
IFPower
Example: SWE:EGAT:SOUR IFP
Switches the gate source to IF power.
Setting Basic Spectrum RF Measurement Parameters