Remote Commands
R&S
®
FPL1000
685
User Manual 1178.3370.02 ─ 09
Manual operation:
See
11.6.7.8
Performing an SEM Measurement
The following commands are required to perform an SEM measurement:
●
SENS:SWE:MODE ESP
●
11.6.7.9
Retrieving Results
The following commands analyze and retrieve measurement results for SEM measure-
ments.
●
●
●
●
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult?
11.6.7.10
Example: SEM Measurement
In this example we will configure and perform an SEM measurement. Note that this
example is primarily meant to demonstrate the remote control commands, it does not
necessarily reflect a useful measurement task. For most common measurement stand-
ards, the R&S
FPL1000 performs the measurement optimally with the predefined set-
tings, without further configuration.
//-----------Preparing the measurement ------------
//Reset the instrument
*RST
//------------ Preparing the measurement------------
//Activate SEM Measurement
SWE:MODE ESP
//Selects single sweep mode.
//SEM has to be in single sweep mode to be configured and no sweep operation
//may be running!
// If required, a sweep stop can be ensured by INIT:IMM;*WAI
INIT:CONT OFF
//------------ Managing Measurement Configurations----------
//Load the 3GPP configuration stored in the file '3GPP_UL.xml'
ESP:PRES 'WCDMA\3GPP\UL\3GPP_UL.xml'
//------------ Defining the Reference Range-----------------
//Query the current reference range.
Configuring and Performing Measurements
