Ronde & Schwarz 1304.0004.03, User Manual

Page: 584 / 1076

Network and Remote Operation
R&S
®
FPL1000
584 User Manual 1178.3370.02 ─ 09
The error message remains in place when you switch to "Local" mode. To close the
message box, select the "Close" icon.
Only the most recent error is displayed in remote mode. However, in local mode, all
errors that occurred during remote operation are listed in a separate tab of the "Net-
work + Remote" dialog box (see
Chapter 10.3.5, "Remote Errors" , on page 588).
Remote command:
SYSTem:ERRor:DISPlay
on page 969
SYSTem:ERRor:CLEar:REMote
on page 973
10.3.3 Compatibility Settings
The R&S FPL1000 can emulate the GPIB interface of other signal and spectrum ana-
lyzers, e.g. in order to use existing control applications.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S FPL1000 supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S
FPL1000 can emulate these other devices, including their default values, in
order to repeat previous measurements or support existing control applications as in
legacy systems.
The required settings are configured in the "Compatibility" tab of the "Network
+Remote" dialog box.
Network and Remote Control Settings