Page
1
of
2
Copyright ROMPA® Ltd
LED ROPE LIGHT 18960, KH 1.11
LED ROPE LIGHT 18960
CONTENTS
Your LED Rope Light is supplied in one box with a controller and mains plug attached
INSTALLATION/OPERATION
Remove all packaging (clear tape around coiled lights).
Install in a suitable place, making sure that the plug can be plugged in without placing any
strain on the cable.
Make sure the position of the rope light does not represent a hazard e.g. do not place
where someone could trip over the rope or get caught up in it.
The use of a safety cut out device or circuit breaker is strongly recommended.
There is no ON/OFF switch – use the controller to operate.
The controller has the following options:
1. COMBINATION
2. IN
WAVES
3. SEQUENTIAL
4. SLO
GLO
5. CHASING/FLASH
6. SLOW
FADE
7. TWINKLE/FLASH
8. STEADY
ON
Press the button at the top to scroll through and select from these options.
These lights may be used outdoors provided that appropriate advice and assistance is
taken from a suitably qualified electrician. The plug and controller must always be kept dry
and safe.
Do not install under carpets or matting or in a place where the rope light could be stood on.
If suspending the lights, make sure the fixtures used (to be purchased separately) are
capable of holding the product’s weight (approximately 3kg)
IMPORTANT
: The LED Rope Light should not be bent – it may be gently curved and
positioned in gentle waves but not bent at acute angles. Bending the LED Rope Light at
acute angles is likely to break the lights inside and cause whole sections of lights to stop
lighting up.