REQUIRED
MIDDLE POSITION
LOWEST
POSITIO
N
HIGHES
T POSITIO
N
HIGHES
T POSITIO
N
MIDDLE POSITION
LOWEST
POSITIO
N
X
X
X
X
Y
Y
Y
Y
STEP 3 (One adult is required in order to complete this step)
There are three different positions for the mattress support (the highest one being intended for a newborn child and the lowest
one for a child that is maximum 35” tall - see cautions note). You must adjust the height of the mattress support (depending on
your child’s height), by inserting all 4 bolts and nuts
(Y)
in the same position (see
FIGURE 2
).
Bolts
(X)
and
(Y)
are factory mounted.
Do not completely tighten the bolts at this step; you will be asked to do so in a later step.
The mattress support will be assembled in the LOWEST POSITION.
ADJUSTING THE HEIGHT OF THE MATTRESS SUPPORT
To adjust the vertical position of the mattress support, you must remove all four bolts and washers
(Y)
, loosen all eight bolts
(5+7,
X)
, lower the frame and insert the bolts and washers
(Y)
back into the corresponding holes, according to the desired height (see
FIGURE 3
). Afterwards, completely tighten all bolts.
The crib is designed in such a manner that, when the mattress support is adjusted to its lowest position, the mattress
support frame must be placed directly over the bottom frame. Before tightening the bolts, we recommend slightly
pressing down on the mattress support, in order to ensure its correct positioning.
WARNING:
IN ORDER TO KEEP YOUR BABY SECURE AND SAFE AND TO AVOID
POTENTIAL INJURY OR DEATH,
IT IS VERY IMPORTANT TO COMPLETELY TIGHTEN ALL
12 BOLTS (X), (Y) & (5+7) AFTER ADJUSTING THE HEIGHT OF THE MATTRESS SUPPORT.
WARNING!
COMPLETELY TIGHTEN!
FIGURE 3
