Quick-operating manual
1. Device preparation
• Insert battery. Watch
the correct polarity.
Close battery com-
partment.
• Connect the hand-
held electrode with the
short cable with a so-
cket of the ESM-2
➐
• Insert the green-yel-
low cable on a groun-
ded plug socket into the ESM-2 other socket
➏
• Switch device on by pushing
➋
2. Person preparation
• Lie down in your bed as usual
• Ensure that the green-yellow ground wire is not on, or
directly near, the person to be measured
3. Measurement
• IMPORTANT: Measure exclusively in daylight (elecrtical
lamps can influence the measurement!)
• Take the hand-held electrode securely in your hand
• Wait until the digital display displays a stable value and
read this off
• This value is somewhere between 0 und 19999
• Note down this value
• In this way, measure all persons in the relevant sleeping
locations
Page 5
