This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
STATEMENT REGARDING FCC COMPLIANCE
REGULATORY COMPLIANCE
Do not dispose of in general waste.
Please recycle batteries and damaged electrical products appropriately.
2014/35/EU
The Low Voltage Directive
2014/30/EU
The Electromagnetic Compatibility Directive
2014/53/EU
The Radio Equipment Directive
Rollease Acmeda declares this equipment is in compliance with the essential
requirements and other relevant provisions of the following directives:
Plug USB power adapter into a power outlet.
Plug the ARC Repeater into the USB power adapter.
A blue LED on the ARC Repeater will be visible
when the power is switched on.
Only use Rollease Acmeda USB power adapters with ARC Repeater.
Using other power adapters/power sources may adversely affect ARC
Repeater performance and should be avoided.
ARC Repeater is plug and play. No setup required.
Press any button on a Rollease Acmeda remote
control. The blue light on the ARC Repeater will
flash 3 times. This means the ARC Repeater is
transmitting the signal.
ARC REPEATER
QUICK START GUIDE
rolleaseacmeda.com
1
2
3
WARNING
NOTE
40m/131ft
40m/131ft
OR
40m/131ft
40m/131ft
OR
Maximum of 2 ARC Repeaters can be used in one project
Don’t cover the ARC Repeater with a metal shield
LED LIGHT
IMPORTANT
