Tap the Settings cog in the top right corner of NOISE and select ‘Connect
BLOCKS’.
Choose your ‘Seaboard Block’ from the Bluetooth MIDI Devices screen to
complete MIDI-over-Bluetooth pairing.
Connect via DNA any additional Blocks that you have purchased to connect
them now.
(Note: additional Blocks should be connected to NOISE either
by DNA or by Bluetooth but not by both.)
You may register your Blocks by tapping ‘Register Blocks’ now.
If you are prompted to update the firmware, you should do so now (see
below).
You are now connected and ready to make music.
3.5.2 Updating Firmware
You may be prompted to update the firmware during this setup. It is essential
that you update to the latest firmware, as periodic updates ensure functionality
and introduce new features.
To update the firmware, launch NOISE and connect your Block. In NOISE, click
the Settings icon in the upper-right corner, and then click “Firmware.” If you
have not already registered your Block, it may be registered now. NOISE will
look for BLOCKS updates. If there are new firmware updates, you may select
“Click to Update.”
(Note: only one Block at a time should be connected via
Bluetooth to NOISE while updating the firmware, and Blocks should be
disconnected from each other via DNA.)
The update will take a few minutes to
process. When the update is finished, your Block will restart. After your Block
restarts, reconnect it to NOISE by clicking “OK” and then clicking on the name
of your Block.
